{"id":"forklift-free","timeLimitSec":300,"questions":[{"id":"fkf-001","section":"loads","q":"Before you leave a forklift unattended, what must you do?","options":["Leave it running so the next driver can start quickly","Leave the forks raised so other people see the truck","Lower the forks, neutralize, shut off power, set brakes","Set the parking brake but leave the key in"],"answer":2,"explain":"1910.178(m)(5)(i): when a truck is left unattended, the load engaging means shall be fully lowered, controls neutralized, power shut off and brakes set."},{"id":"fkf-002","section":"training","q":"Under OSHA's forklift standard, who must certify that an operator has been trained and evaluated?","options":["Any online training website","The forklift manufacturer","OSHA's area office","The operator's employer"],"answer":3,"explain":"29 CFR 1910.178(l)(6) makes the employer certify that each operator has been trained and evaluated. OSHA itself does not issue forklift licenses."},{"id":"fkf-003","section":"travel","q":"A large load blocks your forward view. How should you travel?","options":["Forward, standing up to see","In reverse, looking where you go","Forward, sounding the horn","Forward with the load raised high"],"answer":1,"explain":"1910.178(n)(4) says if the load blocks forward view, travel with the load trailing, and always look in the direction of travel."},{"id":"fkf-004","section":"stability","q":"On a counterbalanced forklift, what does the 'stability triangle' connect?","options":["The truck's three support points","The seat, the wheel and the horn","The battery, engine and tank","The three forks and the mast"],"answer":0,"explain":"OSHA's Appendix A describes the stability triangle as imaginary lines between the truck's three points of support. The truck is stable while the combined center of gravity stays inside it."},{"id":"fkf-005","section":"inspect","q":"How often must a forklift be examined before it is placed in service?","options":["At least daily, or after each shift if run around the clock","Only after a repair or an accident","Once a month, by the forklift dealer","Once a week, by the maintenance department"],"answer":0,"explain":"1910.178(q)(7) requires an examination before the truck is placed in service, at least daily, and after each shift when trucks are used round the clock."}]}